5. Grasp the battery socket release tab with your fingers and gently pull out away from the battery to remove the battery from the battery socket. See
Figure6-3.
6. Place the new battery in the battery socket as shown in Figure6-3.
Figure 6-3. Replacing the Battery
7. Press the battery into the socket until it snaps into place.
8. Install the cooling shroud. See "Installing the Cooling Shroud."
9. Close the system. See "Closing the System" in "Troubleshooting Your System."
10. Enter the System Setup program to confirm that the battery operates properly.
11. From the main screen, select System Time to enter the correct time and date.
Also, re-enter any system configuration information that is no longer displayed on the System Setup screens, and then exit the System Setup program.
12. To test the newly installed battery, see "Troubleshooting the System Battery" in "Troubleshooting Your System."
Fan Assembly
The fan assembly contains three fans and provides cooling for the processor, memory modules, and expansion cards.
Removing the Fan Assembly
1. Open the system. See "Opening the System" in Troubleshooting Your System."
2. Remove the cooling shroud. See "Removing the Cooling Shroud."
3. Disconnect the fan assembly's power cable from the system board. See Figure6-4.
4. Remove the power distribution board. See "Removing the Power Distribution Board."
5. Disengage the three forward-facing snaps on the fan assembly.
6. While pressing the release levers on each end of the fan assembly, lift the fan assembly off the two securing posts and out of the chassis. See
Figure6-4.
Figure 6-4. Installing and Removing the Fan Assembly
Komentarze do niniejszej Instrukcji