Dell PowerVault DP600 Instrukcja Użytkownika Pobierz pdf (Strona 139)

139

the server as a member in the format of Domain/Name.

If protection

fails after completing the steps in the previous procedure, perform the following

steps:

In Administrative Tools, open Component Services.

Expand Computers, expand My Computer, and then click DCOM Config.

In the results pane, right-click DPM RA Service, and then click Properties.

In the Properties dialog box, click the Security tab.

In the Launch and Activation Permissions area, click Edit, and then do one of the

following:

• If the primary DPM server is listed, the Access Control List (ACL) entry might be

incorrect. Remove the entry, and then add the primary DPM server with full

permissions.

• If the primary DPM server is not listed, add the primary DPM server with full

permissions.

How to Perform a Bare Metal Recovery

If you use DPM System Recovery Tool (SRT) to back up the DPM server or a protected

computer, you can perform a bare metal recovery in the case of a hardware failure.

For instructions about recovering a DPM server by using DPM SRT, see "Bare Metal Recovery"

in DPM SRT Help.

See Also

Backup for Bare Metal Recovery

Using DpmSync

DpmSync is a command-line tool that enables you to synchronize the DPM database with the

state of the disks in the storage pool and with the installed protection agents. The DpmSync tool

restores the DPM database, synchronizes the DPM database with the replicas in the storage

pool, restores the Report database, and reallocates missing replicas.

DpmSync Syntax

DpmSync -Sync

DpmSync -DpmDbLoc location

DpmSync -DpmReportDbLoc location

DpmSync -ReallocateReplica

DpmSync -?

Parameters

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 157 158

Brak uwag

Dell PowerVault DP600 Instrukcja Użytkownika Strona 139