Dell Dimension XPS T___ Instrukcja Użytkownika Pobierz pdf (Strona 18)

Lower 3.5-Inch Drive

To remove the lower 3.5-inch drive, perform the following steps:

1. Remove the bezel.

2. Remove the drive cage.

3. Remove the three drive-mounting screws, one from the bottom and two from the left side.

4. Slide the drive out of the drive cage.

When you replace a drive, set the jumpers on the replacement drive to match the jumpers on the drive you removed. For additional information

about jumper settings on EIDE drives, see EIDE Subsystem.

To insert the bottom drive back into the bay, you must slide the drive over the two small grooves on the bottom of the bay.

3.5-Inch Diskette Drive

To remove the 3.5-inch diskette drive, perform the following steps:

1. Remove the bezel.

2. Disconnect the power and interface cables from the back of the diskette drive.

3. Press the two drive-release tabs, and slide the drive out of the drive bay.

Before you install the new drive, transfer the drive-release tabs to the replacement diskette drive.

NOTE: This drive bay is used only in mini tower systems.

Drive-mounting screws (3)

Drive-release tabs (2)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

Brak uwag

Dell Dimension XPS T___ Instrukcja Użytkownika Strona 18