Dell PowerEdge T605 Instrukcja Użytkownika Pobierz pdf (Strona 155)

Installing System Components 155

Open the system. See "Opening the System" on page 68.

Remove the expansion card shroud. See "Removing the Expansion Card

Shroud" on page 72.

Remove the processor shroud. See "Removing the Processor Shroud" on

page 72.

Depending on your configuration, disconnect the following cables from

the system board. See

Figure 6-1

for connector locations.

• Three power-supply cables from the PWR1, PWR2, and PWR3

connectors

• I/O panel cable from the

CTRL_PNL

connector

• SATA cable(s) from the SATA connector(s)

• Diskette data cable from the FLOPPY connector

• PATA data cable from IDE connector

• Expansion card fan cable from the FAN1 connector

• System fan cable from the FAN2 connector

• SAS LED cable from the PERC_LED connector

• SAS/SATA backplane cable from BP_12C connector

• Intrusion switch cable from the INTRUSION connector

If applicable, remove all expansion cards and any attached cables. See

"Removing an Expansion Card" on page 108.

If applicable, remove the RAC card. See "Removing the RAC Card" on

page 118.

If applicable, remove the SAS controller card. See "Removing a SAS

Controller Card" on page 115.

Remove the internal USB memory key, if present. See Figure 6-1 for the

USB socket location.

Remove the TOE hardware key, if present. See Figure 6-1 for the

TOE_KEY socket location.

Remove all memory modules. See "Removing Memory Modules" on

page 133.

NOTE: Record the memory-module socket locations to ensure proper

reinstallation of the memory modules.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 229 230

Brak uwag

Dell PowerEdge T605 Instrukcja Użytkownika Strona 155