Dell Dimension E520 Instrukcja Właściciela Strona 41

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 40
Solving Problems 41
Power Problems
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
RUN THE HARDWARE TROUBLESHOOTER See "Resolving Software and Hardware Incompatibilities"
on page 53.
IF THE POWER LIGHT IS GREEN AND THE COMPUTER IS NOT RESPONDING See "Diagnostic Lights"
on page 47.
IF THE POWER LIGHT IS BLINKING GREEN The computer is in standby mode. Press a key on the
keyboard, move the mouse, or press the power button to resume normal operation.
IF THE POWER LIGHT IS OFF The computer is either turned off or is not receiving power.
Reseat the power cable into both the power connector on the back of the computer and the electrical
outlet.
If the computer is plugged into a power strip, ensure that the power strip is plugged into an electrical
outlet and that the power strip is turned on. Also bypass power protection devices, power strips, and
power extension cables to verify that the computer turns on properly.
Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
Ensure that the main power cable and front panel cable are securely connected to the system board (see
"System Board Components" on page 68).
IF THE POWER LIGHT IS STEADY AMBER A device might be malfunctioning or incorrectly installed.
Ensure that the 12-volt power connector (12V) is securely connected to the system board (see "System
Board Components" on page 68).
Remove and then reinstall the memory modules (see "Installing Memory" on page 70).
Remove and then reinstall any cards (see "Cards" on page 73).
Remove and then reinstall the graphics card, if applicable (see "PCI Express Cards" on page 77).
IF THE POWER LIGHT IS BLINKING AMBER The computer is receiving electrical power, but an
internal power problem might exist.
Ensure that the voltage selection switch is set to match the AC power at your location (if applicable).
See "Back View of the Computer" on page 63.
Ensure that the 12-volt power connector (12V) is securely connected to the system board (see "System
Board Components" on page 68).
Przeglądanie stron 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 161 162

Komentarze do niniejszej Instrukcji

Brak uwag