Dell PowerEdge 2800 Instrukcja Użytkownika

Dell™PowerEdge™2800SystemsService-Only Parts Replacement Procedures Before You Begin Recommended Tools Servicing a Tower System SCSI Backplane

Back to Contents Page 

Back to Contents Page Dell™PowerEdge™2800SystemsService-Only Parts Replacement Procedures Notes, Notices, and Cautions Abbreviations and Acron

Back to Contents Page Dell™PowerEdge™2800SystemsService-Only Parts Replacement Procedures Before You Begin Recommended Tools Servicing a

Figure 1-1. Moving the Drive Tray to the Maintenance Position  5. Disconnect the SCSI data cable(s) from the SCSI backplane. See Figure1-2. Fi

a. Lift the spring-loaded blue retention pin away from the front of the backplane, then slide the backplane upward. b. When the backplane cannot

 4. Remove the system cover.  5. Remove the SCSI hard drives or filler panels from the center drive bay.  6. Slide the drive tray to the maint

 Installing the Control Panel Assembly  1. Holding the new control panel assembly in one hand, feed the control panel cable into the opening in th

Removing the System Board   1. If applicable, remove the bezel.  2. Turn off the system and attached peripherals, and disconnect the system from

 18. To remove the system board: a. Lift up the blue retention pin and slide the system board toward the front of the system to disengage the bo

 8. Slide the power supply(s) back into the system and secure them with the relase levers.  9. Replace the memory modules. See "Installing