Dell Latitude 3330 Instrukcja Właściciela

Dell Latitude 3330Owner's ManualRegulatory Model: P18SRegulatory Type: P18S002

Installing The Battery1. Insert the battery into its slot until the battery clicks into place.2. Follow the procedures in After Working Inside Your Co

4. Remove the memory module from the computer.Installing The Memory1. Insert the memory module into the memory socket and press until the memory click

Installing The Hard Drive1. Align the hard-drive bracket with the hard drive.2. Tighten the screws on the hard drive to secure the hard-drive bracket

Installing the Display Bezel1. Align the display bezel with the display assembly.2. Starting from the top corner, press on the display bezel and work

4. Rotate the display panel over to the keyboard.5. Peel off the adhesive tape that secures the low-voltage differential signalling (LVDS) connection

5. Tighten the screws to secure the display panel to the display assembly.6. Install:a) display bezelb) battery7. Follow the procedures in After Worki

Installing The Keyboard1. Connect the keyboard cable to the system board.2. Insert the keyboard in its compartment.3. Press down until the keyboard cl

5. Disconnect the following cables:– media board– touch pad6. Using a plastic scribe, gently pry the sides of the palmrest and remove it from the comp

Removing The Wireless Local Area Network (WLAN) Card1. Follow the procedures in Before Working on Your Computer.2. Remove:a) batteryb) base coverc) ha

4. Turn over the computer. Disconnect the WLAN cable and release the cable from the routing channel on the bottom base chassis.5. Disconnect the displ

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

6. Remove the screw that secures the right hinge.7. Carefully lift up the display assembly from the computer base.Installing The Display Assembly1. Al

b) keyboardc) hard drived) base covere) battery7. Follow the procedures in After Working Inside Your ComputerRemoving The Coin-Cell Battery1. Follow t

f) hard driveg) palmresth) coin-celli) display assembly3. Disconnect the power connector cable from the system board.4. Remove the screws that secure

h) coin-celli) system boardj) display assembly3. Disconnect the heat sink cable from the system board.4. Loosen the captive screws that secure the hea

3. Remove the screws that secure the HDMI board to the system board.4. Remove the High-Definition Multimedia Interface (HDMI) board from the system bo

4. Unthread the speaker cable from its holder and remove the speakers from the computer.Installing The Speakers1. Place the speakers in its compartmen

Installing The Input/Output (I/O) Board1. Insert the I/O board into its slot.2. Connect the speaker cable to the I/O board.3. Install:a) system boardb

Installing The Power Connector1. Replace the power connector port into its compartment.2. Tighten the screw to secure the power connector port in plac

Option Description• USB Storage Device• CD/DVD/CD-RW Drive• Onboard NICYou can also choose the Boot List option. The options are:• Legacy (Default Set

Option Description• Enable Boot Support• Enable External USB PortDefault Setting: both the options are enabled.USB PowerShare Allows you to configure

ContentsNotes, Cautions, and Warnings...21 Working on

Option DescriptionPassword Bypass Allows you to enable or disable the permission to bypass the System and the Internal HDD password, when they are set

Table 5. Secure BootOption DescriptionSecure Boot Enable Allows you to enable or disable the secure boot. The options are:• Disabled (Default Setting)

Table 6. PerformanceOption DescriptionMulti Core Support This field specifies whether the process will have one or all cores enabled. The performance

Option DescriptionWake on LAN/WLAN This option allows the computer to power up from the off state when triggered by a special LAN signal. Wake-up from

Table 10. WirelessOption DescriptionWireless Switch Allows you to determine which wireless device can be controlled by the wireless switch. The option

3System SetupSystem Setup enables you to manage your computer hardware and specify BIOS‐level options. From the System Setup, you can:• Change the NVR

Keys Navigation<Enter> Allows you to select a value in the selected field (if applicable) or follow the link in the field.Spacebar Expands or co

Table 15. System ConfigurationOption DescriptionIntegrated NIC Allows you to configure the integrated network controller. The options are:• Disabled•

Option Description• Enable Media Card• Disable Media CardDefault Setting: All devices are enabledTable 16. VideoOption DescriptionLCD Brightness Allow

Option Description• TPM Security• TPM ACPI Support• TPM PPI Deprovision Override• Clear• TPM PPI Provision Override• Deactivate (Default setting)• Act

Removing The Heat Sink...

Option DescriptionIf you enable the Custom Mode, the relevant options for PK, KEK, db, and dbx appear. The options are:• Save to File- Saves the key t

Option Description• Wake on ACAuto On Time Allows you to set the time at which the computer must turn on automatically. The options are:• Disabled (De

Option DescriptionFn Key Emulation Allows you to match the <Scroll Lock> key feature of PS-2 keyboard with the <Fn> key feature in an inte

Option Description• Clear LogThermal Events Displays the Thermal event log and allows you to clear the log.• Clear LogPower Events Displays the Power

CAUTION: The password features provide a basic level of security for the data on your computer.CAUTION: Anyone can access the data stored on your comp

NOTE: If you change the System and/or Setup password, re-enter the new password when promoted. If you delete the System and/or Setup password, confirm

46

4Technical SpecificationsNOTE: Offerings may vary by region. The following specifications are only those required by law to ship with your computer. F

AudioType Two-channel high definition audioController IDT 92HD93Stereo Conversion 24-bit (analog-to-digital and digital-to-analog)Interface:Internal H

DisplayRefresh rate 60 HzOperating Angle 0° (closed) to 135°Minimum Viewing Angles:Horizontal 40/45 @ CR >= 10Vertical 15/20 @ CR >= 10Pixel pit

1Working on Your ComputerBefore Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage an

BatteryTemperature range:Operating 0 °C to 35 °C (32 °F to 95 °F)Non-operating –40 °C to 65 °C (–40 °F to 149 °F)Coin-cell battery 3 V CR2032 lithium

EnvironmentalAltitude (maximum):Operating–15.2 m to 3048 m (–50 to 10,000 ft)0° to 35°CNon-Operating -15.20 m to 10,668 m (-50 ft to 35,000 ft)Maximum

52

5Contacting DellNOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill,

6. Close the display and turn the computer upside-down on a flat work surface.NOTE: To avoid damaging the system board, you must remove the main batte

After Working Inside Your ComputerAfter you complete any replacement procedure, ensure you connect any external devices, cards, and cables before turn

Figure 2. Inside view — Front1. Input/Output (I/O) board2. coin-cell battery3. wireless local area network (WLAN) card4. speaker5. system board6. spea

2Removing and Installing ComponentsThis section provides detailed information on how to remove or install the components from your computer.Removing t