
5.6 Installing the library
Choosing a location
Choose a location that meets the following criteria:
Table 7 Location criteria
Criteria Definition
Rack
requirements
Standard 19-inch rack with 4U of clearance
Room
temperature
10-35º C (50-95º F)
Power source AC power voltage: 100-127 VAC; 200-240 VAC
Line frequency: 50-60 Hz
Place the library near an AC outlet. The AC power cord is the
product’s main AC
disconnect device and must be easily accessible at all times.
Weight without
media
Single FH drive unit: 21,3 kg
Two FH drive unit: 24,3 kg
Two HH drive unit: 22,2 kg
Four HH drive unit 26,1 kg
Weight with
media
Single FH drive unit: 30,6 kg
Two FH drive unit: 33,6 kg
Two HH drive unit: 31,4 kg
Four FH drive unit: 35,3 kg
Air quality The library should be placed in an area with minimal sources of
particulate contamination.
Avoid areas near frequently used doors and walkways, stacks of
supplies that collect dust,
printers, and smoke-filled rooms.
Excessive dust and debris can damage tapes and tape drive.
Humidity 20-80 percent RH non-condensing
Clearance Back: Minimum of 15.4 cm (6 inches)
Front: Minimum of 30.8 cm (12 inches) – for mailslot
Minimum of xx cm to remove magazines
Sides: Minimum of 5.08 cm (2 inches)
Unpacking the tape library
Before you begin, clear a work surface to unpack the library. Select an open 4U rack location allowing
easy access to the host server and an easily accessible power outlet
.
CAUTION: If the temperature in the room where the library will be installed varies by 15º C (30º F)
from the room where the library was stored, allow the library to acclimate to the surrounding
environment for at least 12 hours before unpacking it from the shipping container.
Unpacking the library:
1. Before opening and removing the library from the shipping container, inspect the container for
shipping damage. If you notice any damage, report it to the shipping company immediately.
2. Open the shipping container and remove the two rack rails and set aside.
3. Carefully remove the shipping materials from the top of the library. Remove the accessory
package and set aside.
Komentarze do niniejszej Instrukcji