Dell PowerConnect W-Clearpass 100 Software Podręcznik Użytkownika Pobierz pdf (Strona 401)

ClearPass Guest 3.9 | Deployment Guide Administrator Tasks | 401

System Control

The System Control commands on the Administrator > System Control page allow you to:

 Shut down the server immediately.

 Reboot the system which stops all services while the reboot is taking place.

 Restart the system services without stopping the server. This would usually be done after a plugin

installation if required, or if performing other system changes such as installing a new SSL certificate or

changing the server’s time zone.

 Schedule a reboot or shutdown operation to take place at a future point in time.

 Configure the database and advanced system settings

 Configure system-level log files

 Configure Web servers and Web applications.

Changing System Configuration Parameters

The System Configuration form allows “sysctl” parameters to be modified. These parameters may be

used to adjust advanced networking and kernel options and control other system properties that apply at

the operating system level.

Click the Save Changes button to apply the new configuration parameters. The settings will be applied

to the operating system immediately, but in some cases the new settings will not take effect until the system

is rebooted. For this reason, it is recommended that you always reboot after modifying any of these

parameters.

System Log Configuration

The System Log Configuration form allows you to modify options related to locally stored system log

files, including the HTTP access log, HTTP error log, and the general-purpose system message log. You can

also define a remote syslog server to which log messages will be sent, and specify which syslog messages

should be sent.

The syslog protocol is used to send log messages from one system to a syslog server (also known as a

‘collector’). Log messages are grouped according to both facility and priority.

The following priority levels are defined in the protocol:

 0—Emergency: system is unusable

 1—Alert: action must be taken immediately

 2—Critical: critical conditions

 3—Error: error conditions

 4—Warning: warning conditions

If the server’s clock is running slow, changing the server’s time may cause your current login to expire. In this case

you will need to log in again after clicking the Save Changes button.

Changing kernel options to incorrect values can result in a non-functional system. For this reason it is

recommended not to change these values unless you are advised by Aruba support, or you have carefully tested

the result of the change in a controlled environment.

1 2 ... 396 397 398 399 400 401 402 403 404 405 406 ... 517 518

Brak uwag

Dell PowerConnect W-Clearpass 100 Software Podręcznik Użytkownika Strona 401