Dell Force10 E300 Podręcznik Użytkownika Pobierz pdf (Strona 5)

TeraScale to ExaScale Upgrade Procedure 5

TeraScale to ExaScale Upgrade

Be sure you have the correct ExaScale hardware ready for installation prior to beginning this upgrade. Refer to

Supported Hardware for the list of hardware required for E-Series ExaScale with FTOS 8.1.1.1.

Step Command Syntax Command Mode Purpose

1 Turn the On/Standby switch to

Standby (AC).

Turn the Remote Power Source to

Off (DC).

Power-off the chassis.

2 Replace the TeraScale RPMs, SFMs and linecards with ExaScale RPMs, SFMs and linecards.

Refer to the RPM, SFM and Linecard documentation for installation and replacement details.

3 Turn the On/Standby switch to

(AC)

Turn the Remote Power Switch to

(DC).

Power on the chassis

The chassis automatically powers up with a ExaScale image

if the RPM has been programmed to boot

from particular FTP location or Flash that points to a TeraScale image. If no image is configured, go to

Steps 5 and 6.

Ctrl+Shift+6

Stop the chassis in boot user mode and

configure it to boot from FTP or Flash

and reload.

6 boot change

{primary|secondary|default}

After entering the keywords and

desired option, press Enter. The

software prompts you to enter the

following:

• boot device (ftp, tftp, flash, slot0)

• image file name

• IP address of the server with the

image

• username and password (only for

FTP)

BOOT_USER Tell the system where to access the

ExaScale FTOS image used to boot the

system:

•Enter

primary to configure the boot

parameters used in the first attempt

to boot the system.

•Enter

secondary for when the

primary operating system boot

selection is not available.

Enter

default to configure boot

parameters used if the secondary

operating system boot parameter

selection is not available. The default

location should always be the internal

flash device (flash:), and a verified

image should be stored there.

reload

BOOT_USER Restart the chassis to boot with the

specified ExaScale image.

show chassis

EXEC Privilege We can confirm using the show chassis

command.

1 2 3 4 5 6 7 8

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Force10 E300 Podręcznik Użytkownika Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Dell Force10 E300