Dell PowerConnect W-AP224/225 Instrukcja Instalacji Pobierz pdf (Strona 2)

Dell Networking W-AP220 Series

Access Point

Installation Guide

www.dell.com

Dell Networking W-AP220 Series Access Point | Installation Guide

Part Number 0511327-02 | October 2013

Contacting Dell

Web Site Support

Main Website dell.com

Support Website dell.com /support

Documentation Website dell.com /support/manuals

Aruba Wireless Networks

, the registered Aruba the Mobile Edge Company logo, and Aruba Mobility

Management System

. Dell™, the DELL™ logo, and PowerConnect™ are trademarks of Dell Inc.

Originated in the USA. All other trademarks are the property of their respective owners.

Open Source Code

Certain Aruba products include Open Source software code developed by third parties, including software code

subject to the GNU General Public License (GPL), GNU Lesser General Public License (LGPL), or other Open

Source Licenses. The Open Source code used can be found at this site:

http://www.arubanetworks.com/open_source

reserved. This product includes software developed by Lars Fenneberg, et al.

Legal Notice

The use of Aruba Networks, Inc. switching platforms and software, by all individuals or corporations, to terminate

other vendors’ VPN client devices constitutes complete acceptance of liability by that individual or corporation for

this action and indemnifies, in full, Aruba Networks, Inc. from any and all legal actions that might be taken against

it with respect to infringement of copyright on behalf of those vendors.

 Objects that contain water

 Metal

 Microwave ovens

 Wireless phones and headsets

Installing the AP

Using the Ceiling Rail Adapter

The W-AP220 Series access point ships with two ceiling rail adapters for 9/16” and

15/16” ceiling rails. Additional wall mount adapters amd ceiling rail adapters for other

rail styles are available as accessory kits.

1. Pull the necessary cables through a prepared hole in the ceiling tile near where the

AP will be placed.

2. Place the adapter against the back of the AP with the adapter at an angle of

approximately 30 degrees to the tabs (see Figure 6).

3. Twist the adapter clockwise until it snaps into place in the tabs (see Figure 6).

Figure 6

Attaching the Ceiling Rail Adapter

4. If necessary, connect the console cable to the console port on the back of the AP.

5. Hold the AP next to the ceiling tile rail with the ceiling tile rail mounting slots at

approximately a 30-degree angle to the ceiling tile rail (see Figure 7). Make sure

that any cable slack is above the ceiling tile.

6. Pushing toward the ceiling tile, rotate the AP clockwise until the device clicks into

place on the ceiling tile rail.

Figure 7

Mounting the AP

7. On the W-AP224, install the external antennas according to the manufacturer’s

instructions, and connect the antennas to the antenna interfaces on the AP.

Connecting Required Cables

Install cables in accordance with all applicable local and national regulations and

practices.

Power Connection

The W-AP220 Series access point has a single 12V DC power jack socket to support

powering through an AC-to-DC power adapter.

Verifying Post-Installation Connectivity

The integrated LEDs on the AP can be used to verify that the AP is receiving power

and initializing successfully (see Table 1). Refer to the Dell Networking W-Series

ArubaOS Quick Start Guide for further details on verifying post-installation network

connectivity.

Configuring the W-AP220 Series

AP Provisioning/Reprovisioning

Provisioning parameters are unique to each AP. These local AP parameters are

initially configured on the controller which are then pushed out to the AP and stored

on the AP itself. Dell recommends that provisioning settings be configured via the

ArubaOS Web UI only. Refer to the Dell Networking W-Series ArubaOS User Guide

for complete details.

AP Configuration

Configuration parameters are network or controller specific and are configured and

stored on the controller. Network configuration settings are pushed out to the AP(s)

but remain stored on the controller.

Configuration settings can be configured via the ArubaOS Web UI or ArubaOS CLI.

Refer to the Dell Networking W-Series ArubaOS User Guide for complete details.

Product Specifications

Electrical

 Ethernet:

 2 x 10/100/1000Base-T auto-sensing Ethernet RJ-45 Interfaces

 MDI/MDX

 IEEE 802.3 (10Base-T), IEEE 802.3u (100Base-T). IEEE 802.3ab (1000Base-T)

 Power over Ethernet (IEEE 802.3at compliant), 48V DC (nominal) and 56V DC (maximum)/

350mA (see Figure 5 for pin configuration)

 Power:

 12 VDC power interface, supports powering through an AC-to-DC power adapter

 POE support on Ethernet ports: 802.3at-compliant POE sourcing devices

Environmental

 Operating:

 Temperature: 0° C to +50° C (+32° F to +122° F)

 Humidity: 5% to 95% non-condensing

 Storage and transportation:

 -Temperature: -40° C to +70° C (-40° F to +158°)

For additional specifications on this product, please refer to the data sheet. The data sheet can be found at

dell.com.

Safety and Regulatory Compliance

Dell provides a multi-language document that contains country-specific restrictions and additional safety

and regulatory information for Dell hardware products. The Dell Networking W-Series Safety,

Environmental, and Regulatory Information document is included with the controller products.

Regulatory Model Names

The following regulatory model names apply to the W-AP220 Series access point:

 W-AP224: APIN0224

 W-AP225: APIN0225

FCC

The device is electronically labeled and the FCC ID is displayed via the WebUI under the About menu.

FCC Class B Part 15

This device complies with Part 15 of the Federal Communications Commission (FCC) Rules. Operation is

subject to the following two conditions:

 This device may not cause harmful interference.

 This device must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the manufacturer’s instructions, may cause interference harmful

to radio communications.

If this equipment does cause interference, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio or TV technician for help.

Complies with the Class B limits for radio noise emissions as set out in the interference-causing equipment

standard entitled “Digital Apparatus,” ICES-003 of Industry Canada.

Cet apareil numerique de la classe B respecte toutes les exigencies du Reglement sur le materiel brouilleur

du Canada.

EU Regulatory Conformance

Dell, hereby declares that this APIN0224 and APIN0225 device models are in compliance

with the essential requirements and other relevant provisions of Directive 1999/5/EC.

CE(!)The Declaration of Conformity made under Directive 1999/5/EC is available for viewing at dell.com.

Hong Kong

UAE

Medical

1. Equipment not suitable for use in the presence of flammable mixtures.

2. End product system, including power supply, must be evaluated to IEC 60601-1-1 and IEC 60601-1 by

the end user.

3. Wipe with a dry cloth, no additional maintenance required.

4. No serviceable parts, the unit must be sent back to the manufacturer for repair.

5. No modifications are allowed without Dell approval.

Proper Disposal of Dell Equipment

Dispose of Dell products per local regulations. For the most current information about Global

Environmental Compliance and Dell products, visit dell.com

Waste of Electrical and Electronic Equipment

Dell products at end of life are subject to separate collection and treatment in the

EU Member States, Norway, and Switzerland and therefore are marked with the

symbol shown at the left (crossed-out wheelie bin). The treatment applied at end

of life of these products in these countries shall comply with the applicable

national laws of countries implementing Directive 2002/96EC on Waste of

Electrical and Electronic Equipment (WEEE).

China RoHS

Dell products also comply with China environmental declaration requirements and are

labeled with the “EFUP 10” label shown at the left.

European Union RoHS

Aruba Networks Inc., hereby, being the manufacturer of this product, declares

that all CE Marked Dell wirless controller and access points products are

manufactured in accordance to the provisional requirements set forth in the

RoHS Directive 2011/65/EC.

A copy of the Aruba Declaration of Conformity may be obtained upon request from:

Aruba Networks International Ltd.

Building 1000,

Citygate Mahon

Cork Ireland

Please include the regulatory model number located on the product’s regulatory nameplate with the

request.

Note: Service to all Dell Networking products should be performed by trained

service personnel only.

Caution: Make sure the AP fits securely on the ceiling tile rail when

hanging the device from the ceiling, because poor installation could cause

it to fall onto people or equipment.

Note: If both POE and DC power are available, the AP draws power from the PoE

source.

AP-220_04

AP-220_005

Note: If a power adapter other than the one provided by Dell Networks is used in

the US or Canada, it should be cULus (NRTL) Listed, with an output rated 12 VDC,

minimum 1.25A, marked “LPS” or “Class 2,” and suitable for plugging into a

standard power receptacle in the US and Canada.

Caution: RF Radiation Exposure Statement: This equipment complies with FCC RF

radiation exposure limits. This equipment should be installed and operated with a

minimum distance of 7.9 inches (20 cm) between the radiator and your body for

2.4 GHz and 5 GHz operations. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter. When operated in

the 5.15 to 5.25 GHz frequency range, this device is restricted to indoor use to

reduce the potential for harmful interference with co-channel Mobile Satellite

Systems.

Caution: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate this

equipment.

HK0011300681

HK0011300680

TRA

REGISTERED No:

DEALER No:

DA0039425/10

ER0111798/13

TRA

REGISTERED No:

DEALER No:

DA0039425/10

ER0111795/13

Singapore

200202320G

1 2

Installation Guide 1
Access Point 2

Komentarze do niniejszej Instrukcji

Brak uwag

Dell PowerConnect W-AP224/225 Instrukcja Instalacji Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Punkty dostępu do sieci WLAN Dell PowerConnect W-AP224/225