Dell Label Maker DCSM Instrukcja Użytkownika Pobierz pdf (Strona 29)



3. Disconnect the power and data cables from the back of the floppy drive.



4. Remove the floppy drive by sliding and holding the drive latch release downward. Then, slide the drive out of the computer.



Installing a Floppy Drive

power cable

data cable

NOTE: If you are installing a PCI Express x16 card, this card may cover the floppy-drive connectors. Remove this card before connecting the floppy-drive

cables.

sliding plate lever

sliding plate

floppy drive

NOTE: In the event the replacement or new floppy drive does not have the shoulder screws, use the screws located within the drive panel insert.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 54 55

Notes, Notices, and Cautions 1
Abbreviations and Acronyms 1
Front View of Computer 2
Back View of Computer 3
 Advanced Troubleshooting 5
System Lights 6
Diagnostic Lights 7
 Beep Codes 8
 Before You Begin 10
Memory 14
Installing Memory 15
Cards 16
Installing a PCI Card 17
Removing a PCI Card 18
PCI Express Cards 19
Drive Panels 22
Replacing the Drive Panel 23
Drives 24
IDE Drive Addressing 25
Connecting Drive Cables 25
Drive Interface Connectors 25
Power Cable Connector 25
Hard Drive 26
Installing a Hard Drive 27
Adding a Second Hard Drive 27
Floppy Drive 28
Installing a Floppy Drive 29
Media Card Reader 31
CD/DVD Drive 33
Installing a CD/DVD Drive 34
Processor 36
Installing the Processor 37
System Board 38
Jumper Settings 39
Removing the System Board 39
Power Supply 40
Replacing the Power Supply 41
Battery 42
 Specifications 43
System Setup 46
System Setup Options 47
Boot Sequence 49
Clearing CMOS Settings 50
 Technical Overview 52
DC Power Connector P1 53
Abbreviations and Acronyms 55

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Label Maker DCSM Instrukcja Użytkownika Strona 29

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Dell Label Maker DCSM