Dell PowerConnect W-Airwave 8.0 Instrukcja Instalacji Pobierz pdf (Strona 3)

Installing Linux CentOS 6.2 (Phase 1)

Perform the following steps to install the Linux CentOS 6.2 operating system. The Linux installation is a prerequisite to

installing AirWave on the network management system.

This procedure erases the hard drive(s) on the server.

1. Insert the AirWave installation DVD into the drive and boot the server.

2. Type install and press Enter.

To configure the partitions manually, type manual and press Enter.

Figure 1:AirWave Installation

3. Allow the installation process to continue. Installing the CentOS software (Phase I) takes 10 to 20 minutes to

complete. This process formats the hard drive and launches Anaconda to install all necessary packages. Anaconda

gauges the progress of the installation.

Upon completion, the system will prompt you to eject the installation DVD and reboot the system. The

GRUBscreen will appear upon reboot.

4. Remove the DVD from the drive and store it in a safe location.

Installing the AirWave Software (Phase 2)

Getting Started

Perform the following steps when the GRUB screen appears.

1. Press Enter or wait six seconds. The system automatically loads the kernel.

2. When the kernel is loaded, log into the server using the following credentials:

l login = root

l password = admin

3. Start the AirWave software installation script by executing the ./amp-install command.

Type ./amp-install at the command prompt and press Enter to execute the script.

Step 1: Configuring Date and Time

The following message appears. This step ensures the proper date and time are set on the server.

Dell Networking W-AirWave 8.0 | Installation Guide 3

1 2 3 4 5 6 7 8 ... 20 21

Brak uwag

Dell PowerConnect W-Airwave 8.0 Instrukcja Instalacji Strona 3