------------------------ Date and Time Configuration ------------------
Current Time: Fri May 30 09:18:12 PST 2014
1) Change Date and Time
2) Change Time Zone
0) Finish
Ensure that you enter the accurate date and time during this process. Errors will arise later in the installation if the
specified date varies significantly from the actual date, especially if the specified date is in the future and it is fixed later.
Best practices is to configure NTPD to gradually adjust your clock to the correct time.
1. Select 1 to set the date and select 2 to set the time zone. Press Enter after each configuration to return to the message
menu above.
Changing these settings after the installation can cause data loss, especially for time-series data such as Client and
Usage graphs. Avoid delayed configuration.
2. Press 0 to complete the configuration of date and time information and to continue to the next step.
Step 2: Checking for Prior Installations
The following message appears after the date and time are set:
Welcome to AMP Installer Phase 2
STEP 2: Checking for previous AMP installations
If a previous version of AirWave software is not discovered, the installation program automatically proceeds to Step 3. If
a previous version of the software is discovered, the following message appears on the screen.
The installation program discovered a previous version of the software. Would you like to
reinstall AMP? This will erase AMP's database. Reinstall (y/n)?
Type y and then press Enter to proceed.
This action erases the current database, including all historical information. To ensure that the AMP database is backed up
prior to reinstallation, answer `n` at the prompt above and contact your Value Added Reseller or directly contact Dell
support.
Step 3: Installing AMP Software
The following message appears while the AirWave software is transferred and compiled.
STEP 3: Installing AMP software
This will take a few minutes.
Press Alt-F9 to see detailed messages.
Press Alt-F1 return to this screen.
This step requires no user input, but you can follow the instructions to monitor its progress and switch back to the
installation screen.
Step 4: Checking the AirWave Installation
After the AirWave software installation is complete, the following message appears:
STEP 4: Checking AMP installation
Database is up.
AMP is running version: (version number)
This step requires no user input. Proceed to the next step when prompted to do so.
Step 5: Assigning an IP Address to the AMP System
While the AirWave primary network interface accepts a DHCP address initially during installation, AirWave does not
function when launched unless a static IP is assigned. Complete these tasks to assign the static IP address. The following
4 Dell Networking W-AirWave 8.0 | Installation Guide
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji