Dell PowerEdge 2800 Instrukcja Naprawy Pobierz pdf (Strona 52)



Installing a Power Supply



1. If you are adding a second power supply, remove the power supply filler panel. See "Removing the Power Supply Bay Filler Panel."



2. Holding the release lever in the open position, slide the new power supply into the chassis until the release lever contacts the system chassis. See

Figure6-9.



3. Close the release lever until the power supply is fully seated.



4. Lock the retention lever in place using the thumbscrew. See Figure6-9.



5. Connect the power cable to the power supply and plug the cable into a power outlet.

After installing a new power supply in a system with two power supplies, allow several seconds for the system to recognize the power supply and determine

whether it is working properly. The power-on indicator will turn green to signify that the power supply is functioning properly (see Figure2-4).



Removing the Power Supply Bay Filler Panel



1. Grasp the filler panel using the two holes. See Figure6-10.



2. Lift the panel upwards, then rotate the lower edge of the panel away from the system back panel. See Figure6-10.

Figure 6-10. Removing the Power Supply Bay Filler Panel

NOTICE: When connecting the power cable, insert the cable through the strain-relief loop.