Dell Lifecycle Controller 2 Version 1.3.0 Instrukcja Obsługi Pobierz pdf (Strona 201)

the RebootJobType in the input xml. You should not enter “0” or give no parameter at all in the input

XML.

EXAMPLE:

wsman invoke -a CreateTargetedConfigJob

http://schemas.dmtf.org/wbem/wscim/1/cimschema/

2/root/dcim/DCIM_BIOSService

?SystemCreationClassName=DCIM_ComputerSystem,

CreationClassName=DCIM_BIOSService,SystemName=DCIM:ComputerSystem,

Name=DCIM:BIOSService -h $IPADDRESS -V -v -c dummy.cert -P 443

-u $USERNAME -p $PASSWORD

-J CreateTargetedConfigJob_BIOS.xml -j utf-8 -y basic

The input file CreateTargetedConfigJob_BIOS.xml is shown below:

<p:CreateTargetedConfigJob_INPUT

xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-

schema/2/root/dcim/DCIM_BIOSService">

<p:Target>BIOS.Setup.1-1</p:Target>

<p:RebootJobType>2</p:RebootJobType>

<p:ScheduledStartTime>TIME_NOW</p:ScheduledStartTime>

<p:UntilTime>20111111111111</p:UntilTime>

</p:CreateTargetedConfigJob_INPUT>

OUTPUT:

After running this method, a

jobid

or a message is displayed indicating an error. The status of this

jobid

can be checked within the job control provider in Section 10.

<n1:CreateTargetedConfigJob_OUTPUT>

<n1:Job>

<wsa:Address>http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anon

ymous</wsa:Address>

<wsa:ReferenceParameters>

<wsman:ResourceURI>http://schemas.dell.com/wbem/wscim/1/cimschema/

2/DCIM_LifecycleJob</wsman:ResourceURI>

<wsman:SelectorSet>

<wsman:Selector Name="InstanceID">JID_001300720080</wsman:Selector>

<wsman:Selector Name="__cimnamespace">root/dcim</wsman:Selector>

</wsman:SelectorSet>

</wsa:ReferenceParameters>

</n1:Job>

<n1:ReturnValue>4096</n1:ReturnValue>

</n1:CreateTargetedConfigJob_OUTPUT>

17.8 Deleting the Pending Values for BIOS and Boot-

DeletePendingConfiguration()

This method is called to cancel the pending values created by the SetAttribute() and SetAttributes()

methods. The DeletePendingConfiguration() method cancels the pending configuration changes made

before the configuration job is created with CreateTargetedConfigJob(). This method only operates on

the pending changes prior to CreateTargetedConfigJob() being called. After the configuration job

is created, the pending changes can only be canceled by calling DeleteJobQueue() in the Job

Control profile.

Invoke CreateTargetedConfigJob() with the following parameters and syntax:

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 239 240

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Lifecycle Controller 2 Version 1.3.0 Instrukcja Obsługi Strona 201

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell Lifecycle Controller 2 Version 1.3.0