Dell PowerConnect W-Airwave 7.7 Instrukcja Instalacji Pobierz pdf (Strona 5)

Installing the AirWave Software (Phase 2)

Getting Started

Perform the following steps when the GRUB screen appears.

1. Press Enter or wait six seconds. The system automatically loads the kernel.

2. When the kernel is loaded, log into the server using the following credentials:

l login = root

l password = admin

3. Start the AirWave software installation script by executing the ./amp-install command.

Type ./amp-install at the command prompt and press Enter to execute the script.

Step 1: Configuring Date and Time

The following message appears. This step ensures the proper date and time are set on the server.

------------------------ Date and Time Configuration ------------------

Current Time: Fri May 24 09:18:12 PST 2013

1) Change Date and Time

2) Change Time Zone

0) Finish

Ensure that you enter the accurate date and time during this process. Errors will arise later in the installation if the

specified date varies significantly from the actual date, especially if the specified date is in the future and it is fixed later.

Best practices is to configure NTPD to gradually adjust your clock to the correct time.

1. Select 1 to set the date and select 2 to set the time zone. Press Enter after each configuration to return to the message

menu above.

Changing these settings after the installation can cause data loss, especially for time-series data such as Client and

Usage graphs. Avoid delayed configuration.

2. Press 0 to complete the configuration of date and time information and to continue to the next step.

Step 2: Checking for Prior Installations

The following message appears after the date and time are set:

Welcome to AMP Installer Phase 2

STEP 2: Checking for previous AMP installations

If a previous version of AirWave software is not discovered, the installation program automatically proceeds to Step 3. If

a previous version of the software is discovered, the following message appears on the screen.

The installation program discovered a previous version of the software. Would you like to

reinstall AMP? This will erase AMP's database. Reinstall (y/n)?

Type y and then press Enter to proceed.

This action erases the current database, including all historical information. To ensure that the AMP database is backed up

prior to reinstallation, answer `n` at the prompt above and contact your Value Added Reseller or directly contact Dell

support at dell.com/support.

Step 3: Installing AMP Software

The following message appears while the AirWave software is transferred and compiled.

STEP 3: Installing AMP software

This will take a few minutes.

Press Alt-F9 to see detailed messages.

Dell Networking W-AirWave 7.7 | Installation Guide 5

1 2 3 4 5 6 7 8 9 10 ... 18 19

Brak uwag

Dell PowerConnect W-Airwave 7.7 Instrukcja Instalacji Strona 5