
Diagnostics Indicator Codes
Four diagnostic indicator lights are located behind the bezel on the I/O control panel. To access the lights, see Opening the System. These lights display error
codesduringsystemstartup.Table1-4 lists the causes and corrective actions associated with these codes and the power light status before system POST.
Table1-4 lists the causes and possible corrective actions for these codes during POST. A highlighted circle indicates the light is on; a non-highlighted circle
indicates the light is off.
Table 1-4. Diagnostic Indicator Lights
Setup program. See Using the System Setup Program.
Indicates that network data is being sent or received.
When off at the same time that the activity indicator is off, the NIC
is not connected to the network or the NIC is disabled in the
System Setup program. See Using the System Setup Program.
No power is applied to the
system.
See Troubleshooting Power Supplies.
A possible processor
failure has occurred.
See Troubleshooting the Microprocessor.
See Troubleshooting System Memory.
Possible expansion-card
failure.
See Troubleshooting Expansion Cards.
Possible video card failure.
See Troubleshooting Expansion Cards.
Diskette or hard-drive
failure.
Ensure that the diskette drive and hard drive(s) are
properly connected. See Troubleshooting a Hard Drive
for information on the drive(s) installed in your
system.
See Troubleshooting a USB Device.
No memory modules
detected.
See Troubleshooting System Memory.
Memory configuration
error.
See Troubleshooting System Memory.
Possible system board
resource and/or system
board hardware failure.
Komentarze do niniejszej Instrukcji