Dell Brocade 300 Podręcznik Użytkownika Pobierz pdf (Strona 538)

100

101

538 Fabric OS Administrator’s Guide

53-1002745-02

Configuring trunk groups

After you install the Trunking license, you must re-initialize the ports that are to be used in trunk

groups so that they recognize that trunking is enabled. This procedure needs to be performed only

once, and is required for all types of trunking.

To re-initialize the ports, you can either disable and then re-enable the switch, or disable and then

re-enable the affected ports.

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the islShow command to determine which ports are used for ISLs.

3. Enter the portDisable command for each port to be used in a trunk group.

Alternatively, you can enter the switchDisable command to disable all ports on the switch.

4. Enter the portEnable command for each port that you disabled in step 3, or enter the

switchEnable command to enable all of the ports on the switch.

NOTE

F_Port trunking requires additional steps to configure the Trunk Area (TA). See “Configuring F_Port

trunking for an Access Gateway” on page 544 or “Configuring F_Port trunking for a Brocade adapter”

on page 545 for information.

Enabling trunking on a port or switch

You can enable trunking for a single port or for an entire switch. Because trunking is automatically

enabled when you install the Trunking license, you need to use this procedure only if trunking has

been subsequently disabled on a port or switch. Enabling trunking disables and re-enables the

affected ports. As a result, traffic through these ports may be temporarily disrupted.

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the portCfgTrunkPort command to enable trunking on a port.

Enter the switchCfgTrunk command to enable trunking on all ports on the switch.

Mode 1 enables and mode 0 disables trunking.

In the following example, trunking is being enabled on slot 1, port 3.

switch:admin> portcfgtrunkport 1/3 1

Disabling trunking on a port or switch

You can disable trunking for a single port or for an entire switch. Disabling trunking disables and

re-enables the affected ports. As a result, traffic through these ports may be temporarily disrupted.

Trunking on ICLs is always enabled and cannot be disabled.

Disabling trunking fails if a Trunk Area (TA) is enabled on the port. Use the portTrunkArea command

to remove the TA before disabling trunking.

1 2 ... 533 534 535 536 537 538 539 540 541 542 543 ... 665 666

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Brocade 300 Podręcznik Użytkownika Strona 538

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell Brocade 300