Dell Brocade 300 Podręcznik Użytkownika Pobierz pdf (Strona 589)

100

101

Fabric OS Administrator’s Guide 589

53-1002745-02

EX_Port frame trunking configuration

------------------------

7/3 1000

7/4 1000

7/9 1000

7/10 1000

7/13 1000

10/0 1000

You can also use the fcrRouteShow command to display the router port cost.

To display the router port cost for a single EX_Port, enter the fcrRouterPortCost command with

a port and slot number.

switch:admin> fcrrouterportcost 7/10

Port Cost

------------------------

7/10 1000

4. Enter the appropriate form of the fcrRouterPortCost command based on the task you want to

perform:

• To set the router port cost for a single EX_Port, enter the command with a port and slot

number and a specific cost:

switch:admin> fcrrouterportcost 7/10 10000

• To set the cost of the EX_Port back to the default, enter a cost value of 0:

switch:admin> fcrrouterportcost 7/10 0

5. Enter the portEnable command to enable the ports that you disabled in step 1.

switch:admin> portenable 7/10

EX_Port frame trunking configuration

You can configure EX_Ports to use frame-based trunking just as you do regular E_Ports. EX_Port

frame trunking support is designed to provide the best utilization and balance of frames

transmitted on each link between the FC router and the edge fabric. You should trunk all ports

connected to the same edge fabrics.

The FC router front domain has a higher node WWN—derived from the FC router—than that of the

edge fabric. Therefore, the FC router front domain initiates the trunking protocol on the EX_Port.

After initiation, the first port from the trunk group that comes online is designated as the master

port. The other ports that come online on the trunk group are considered the slave ports. Adding or

removing a slave port does not cause frame drop; however, removing a slave port causes the loss

of frames in transit.

The restrictions for EX_Port frame trunking are the same as for E_Ports—all the ports must be

adjacent to each other using the clearly marked groups on the front of the product.

ATTENTION

This feature should be enabled only if the entire configuration is running Fabric OS v5.2.0 or later.

If router port cost is used with EX_Port trunking, the master port and slave ports share the router

port cost of the master port.

1 2 ... 584 585 586 587 588 589 590 591 592 593 594 ... 665 666

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Brocade 300 Podręcznik Użytkownika Strona 589

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell Brocade 300