Dell Force10 Z9000 Instrukcja Użytkownika Pobierz pdf (Strona 333)

100

101

NOTE: Hash-based load-balancing on multi-protocol label switching (MPLS) does not work when

you enable packet-based hashing (load-balance ip-selection packet-based).

Load-Balancing on the S- Series

For LAG hashing on the the source IP, destination IP, source transmission control protocol (TCP)/user

datagram protocol (UDP) port, and destination TCP/UDP port are used for hash computation by default.

For packets without a Layer 3 header, Dell Networking OS automatically uses load-balance mac

source-dest-mac.

Do not configure IP hashing or MAC hashing at the same time. If you configure an IP and MAC hashing

scheme at the same time, the MAC hashing scheme takes precedence over the IP hashing scheme.

To change the IP traffic load-balancing default, use the following command.

• Replace the default IP 4-tuple method of balancing traffic over a port channel.

CONFIGURATION mode

[no] load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac |

source-dest-mac | source-mac]} | {tcp-udp enable} {ipv6-selection} {tunnel}|

{ingress-port}

You can select one, two, or all three of the following basic hash methods:

– ip-selection [dest-ip | source-ip] — Distribute IP traffic based on the IP destination or

source address.

– mac [dest-mac | source-dest-mac | source-mac] — Distribute IPV4 traffic based on the

destination or source MAC address, or both, along with the VLAN, Ethertype, source module ID

and source port ID.

– tcp-udp enable — Distribute traffic based on the TCP/UDP source and destination ports.

– ingress-port — Option to Source Port Id for ECMP/ LAG hashing.

– ipv6-selection— Set the IPV6 key fields to use in hash computation.

– tunnel— Set the tunnel key fields to use in hash computation.

Changing the Hash Algorithm

The load-balance command selects the hash criteria applied to port channels.

If you do not obtain even distribution with the load-balance command, you can use the hash-

algorithm command to select the hash scheme for LAG, ECMP and NH-ECMP. You can rotate or shift

the 12–bit Lag Hash until the desired hash is achieved.

The nh-ecmp option allows you to change the hash value for recursive ECMP routes independently of

non-recursive ECMP routes. This option provides for better traffic distribution over available equal cost

links that involve a recursive next hop lookup.

To change to another algorithm, use the second command.

• Change the default (0) to another algorithm and apply it to ECMP, LAG hashing, or a particular line

card.

CONFIGURATION mode

Interfaces

333

1 2 ... 328 329 330 331 332 333 334 335 336 337 338 ... 936 937

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Force10 Z9000 Instrukcja Użytkownika Strona 333

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell Force10 Z9000