Dell PowerConnect W-Airwave 7.1 Instrukcja Użytkownika Pobierz pdf (Strona 105)

Dell PowerConnect W AirWave 7.1 | User Guide Configuring and Using Device Groups in AWMS | 105

11. To configure Colubris-only settings in this device group, locate the Colubris section and define the required

fields. Table 68 describes the settings and default values.

12. To configure Symbol-only settings, l

ocate the Symbol section and define the required fields. Table 69

describes the settings and default values.

13. To configure Enterasys R2 settings, locate

the Enterasys R2 section and define the required fields. Table 69

describes the settings and default values.

14. Click Save wh

en radio configurations as described above are complete, or click Save and Apply to retain

changes and push them to network devices. Click Revert to return to the last saved changes.

Table 68 Colubri

s-only Fields and Default Values

Setting Default Description

Rogue Scanning Yes If enabled, Colubris access points in the group will passively scan for rogue access

points at the specified interval. This rogue scan will not break a user’s association

to the network.

Rogue Scanning Interval

(10-6

00 secs)

600 If rogue scanning is enabled, this setting controls the frequency with which scans

are conducted (in minutes). Frequent scans provide the greatest security, but AP

performance and throughput available to user devices may be impacted modestly

during a rogue scan.

Automatic Channel Interval 12 Hours Sets the frequency by which APs monitor radio channels for availability and

tivity.

First Radio 802.11b only

1 Mbps

Sets the operational mode and multicast data rate for the first Colubris radio.

Second Radio

(CN330 only)

802.11b only

1 Mbps

Sets the operational mode and multicast data

rate for the second Colubris radio,

supported only for the Colubris CN330.

Table 69 Symbol-only Fields and Default Values

Setting Default Description

Rogue Scanning Yes If enabled, Symbol access points with 3.9.2 or later firmware in the group will

passively scan for rogue access points at the specified interval. This rogue scan

will not break a user’s association to the network.

Rogue Scanning Interval (5-

480

min)

240 If rogue scanning is enabled, this setting controls the frequency with which scans

are conducted (in minutes). Frequent scans provide the greatest security, but AP

performance and throughput available to user devices may be impacted modestly

during a rogue scan.

Table 70 Enterasys Section Fields and Default Values

Setting Default Description

Operational Mode 802.11b +

802.11g

Drop-down menu defines the 802.11 settings to support with the Enterasys radio

devices in this group. Supported options are as follows:

 802.11a only

 802.11b only

 802.11g only

 802.11b + 802.11g

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 333 334

Komentarze do niniejszej Instrukcji

Brak uwag

Dell PowerConnect W-Airwave 7.1 Instrukcja Użytkownika Strona 105

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell PowerConnect W-Airwave 7.1