Dell PowerConnect W-Airwave 7.1 Instrukcja Użytkownika Pobierz pdf (Strona 56)

56 | Configuring AWMS Dell PowerConnect W AirWave 7.1 | User Guide

6. On the Device Setup > Communication page, locate the ICMP Settings section. Complete the settings or

revise the default values as required. Table 23 itemizes the setting and defaul

t value of this section.

7. On the Dev

ice Setup > Communication page, locate the Colubris Administration Options section You only

need to provide this information if you use Colubris APs on your network. Select one of the options listed.

Figure 25 illustrates this section and Table 24 explains related fields.

Figure 25 Device Setup > C

ommunication > Colubris Administration Options Section Illustration

8. On the Device Setu

p > Communication page, locate the Cisco Aironet VxWorks User Creation Options

section. You only need to provide this information if you use VxWorks-based Cisco APs on your network, as

follows:

 Aironet 340

 Aironet 350

 Aironet 1200

Select one of the three options listed. Table 25 describes the settings and defaul

t values of this section.

Table 23 Device Set

up > Communication > ICMP Settings Fields and Default Values

Setting Default Description

Attempt to

ping down

devices

Yes Enables a function that applies when an AP is unreachable over SNMP.

 When Yes is selected, this option has AWMS attempt to ping the AP device.

 Select No if performance is affected in negative fashion by this function. If a large number of

APs are unreachable by ICMP, likely to occur where there is in excess of 100 APs, the timeouts

start to impede network performance.

NOTE: If

ICMP is disabled on the network, select No to avoid the performance penalty caused by

numerous ping requests.

Table 24 Colubris Administration Options Fields and Default Values

Setting Default Description

Do not modify

security/HTTPS

settings

N/A Enables AWMS to use only an existing user account on the AP. This user account must have

all permissions set. The user accounts are defined in the Colubris Username/Password

section in the Default Secrets area.

Replace existing

ser with specified

user

Disabled When enabled, this setting allows you to define a new Colubris username and password on

each Colubris AP.

New Colubris

Username and

Pass

word

N/A Specifies the username and password to be used only if the option Replace existing user with

specified user is selected.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 333 334

Komentarze do niniejszej Instrukcji

Brak uwag

Dell PowerConnect W-Airwave 7.1 Instrukcja Użytkownika Strona 56

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell PowerConnect W-Airwave 7.1