Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Instrukcja Właściciela Pobierz pdf (Strona 44)



6. Wait 30 seconds for the heat sink to loosen from the processor.



7. Open the other heat sink retention lever.



8. If the heat sink has not separated from the processor, carefully rotate the heat sink in a clockwise, then counterclockwise, direction until it releases from

the processor. Do not pry the heat sink from the processor.



9. Lift the heat sink off of the processor and set the heat sink upside down so as not to contaminate the thermal grease.



10. Pull the socket-releaselever90degreesupwarduntiltheprocessorisreleasedfromthesocket.SeeFigure3-14.



11. Rotate the processor shield upward and out of the way.

Figure 3-14. Installing and Removing the Processor



12. Lift the processor shield to release the processor, and then lift the processor out of the socket. Leave the release lever up so that the socket is ready

for the new processor.



Installing a Processor



1. Unpack the new processor.



2. Align the processor with the socket keys on the ZIF socket. See Figure3-14.

heat sink

heat-sink retention lever (2)

retention lever latch

socket key (2)

notch in processor

processor shield

processor

socket-release lever

ZIF socket

NOTICE: Be careful not to bend any of the pins on the LGA socket when removing the processor. Bending the pins can permanently damage the

socket and system board.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 80 81

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Instrukcja Właściciela Strona 44

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Serwery Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)