Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Instrukcja Właściciela Pobierz pdf (Strona 51)



5. Disconnect the SAS cable and power cable from the backplane.

If you are removing a 3.5-inch hard drive (two-drive) backplane, see Figure3-20.



6. Remove the backplane

If you are removing a 3.5-inch hard drive (two-drive)backplane,pressthereleaselatchattheleftendoftheboard,slidetheboardtoitsright,andlift

thebackplaneoffofthesecuringtabs.SeeFigure3-20.

Figure 3-20. 3.5-Inch Hard Drive Backplane Board Removal and Installation



Installing the Backplane Board



1. Replace the backplane board:

When you are installing a 3.5-inch hard drive (two-drive) backplane, fit the board onto the securing tabs, press the release latch at the left end of the

board and slide the board to its left. See Figure3-20.



2. Connect the SAS cable and power cable to the backplane connectors.



3. Reinstall the hard drives.



4. Close the system.



5. If applicable, install the bezel.

Sideplane Board



Removing the Sideplane Board



backplane board release latch

backplane board

securing slots

securing tabs

SAS interface cable

power cable

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.

NOTE: Reinstall the hard drives in the same drive bays from which they were removed.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 80 81

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Instrukcja Właściciela Strona 51

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Serwery Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)