Dell PowerConnect W Clearpass 100 Software Podręcznik Użytkownika Strona 128

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 127
128128 | Authentication
Dell PowerConnect W-Series Aruba Instant 6.2.1.0-3.3 | User Guide
2. Select the Admin tab. The Admin tab details are displayed. The following figure shows the contents of the Admin
tab:
Figure 43 Admin Tab: Management Authentication Parameters
3. Under Local, select any of the following options from the Authentication drop-down list:
l Internal Select this option to specify a single set of user credentials. Enter the Username and Password for
accessing the Virtual Controller Management User Interface.
l RADIUS Server Specify one or two RADIUS servers to authenticate clients. If two servers are configured,
users can use them in primary or backup mode or load balancing mode. To enable load balancing, select
Enabled from the Load balancing drop-down list.
l RADIUS server w/ fallback to internal Select this option to use both internal and external servers. When
enabled, the authentication switches to Internal if there is no response from the RADIUS server (RADIUS
server timeout). To complete this configuration, perform the following steps:
a. To enable load balancing, select Enabled from the Load balancing drop-down list.
b. Specify a Username and Password.
c. Retype the password to confirm.
4. Click OK.
In the CLI
To configure management authentication settings:
(Instant Access Point) (config)# mgmt-auth-server <server1>
(Instant Access Point) (config)# mgmt-auth-server <server2>
(Instant Access Point) (config)# mgmt-auth-server-load-balancing
Przeglądanie stron 127
1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 295 296

Komentarze do niniejszej Instrukcji

Brak uwag