Dell PowerConnect W Clearpass 100 Software Podręcznik Użytkownika Strona 263

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 262
AOS-W Instant 6.2.1.0-3.3| User Guide OAW-IAP Management | 263
Chapter 27
OAW-IAP Management
This section provides information on the following procedures:
l Configuring LED Display on page 263
l Backing up and Restoring OAW-IAP Configuration Data on page 263
l Converting an OAW-IAP to a Remote AP and Campus AP on page 264
l Resetting a Remote AP or Campus AP to an OAW-IAP on page 268
l Rebooting the OAW-IAP on page 268
Configuring LED Display
The LED display is always in the Enabled mode during the an OAW-IAP reboot.
You can enable or disable LEDDisplay for an OAW-IAP using either Instant UI or CLI.
In the Instant UI
To enable or disable LEDdisplay for all OAW-IAPs in an Instant network, perform the following steps:
1. In the Instant main window, click the System link. The System window appears.
2. In the General tab of System window, click Show advanced options to display the advanced options.
3. From the LED Display drop-down menu, select Enabled to enable LED display or Disabled to turn off the LED
display.
4. Click OK.
In the CLI
To enable or disable LEDdisplay:
(Instant Access Point)(config)# led-off
(Instant Access Point)(config)# no led-off
(Instant Access Point)(config)# end
(Instant Access Point)# commit apply
Backing up and Restoring OAW-IAP Configuration Data
You can back up the OAW-IAP configuration data and restore the configuration when required.
Viewing Current Configuration
To view the current configuration on the OAW-IAP:
l In the Instant UI, navigate to Maintenance>Configuration>Current Configuration.
l In the CLI, enter the following command at the command prompt:
(Instant Access Point)# show running-config
Backing up Configuration Data
To back up the OAW-IAP configuration data:
Przeglądanie stron 262
1 2 ... 258 259 260 261 262 263 264 265 266 267 268 ... 295 296

Komentarze do niniejszej Instrukcji

Brak uwag