Dell PowerConnect W-Airwave 7.2 Instrukcja Użytkownika Pobierz pdf (Strona 48)

48 | Configuring AWMS Dell PowerConnect W AirWave 7.2 | User Guide

The Edit button edits the default credentials for newly discovered devices. To modify the credentials for

existing devices, use the APs/Devices > Manage page or the Modify Devices link on the APs/Devices > List

page.

2. Browse to the Device Setup > Communication page, locate the SNMP Settings section, and enter or revise

the following information. Table 20 lists the settings and default values.

3. Locate the SNMP v3 Informs section. Select Add New SNMP v3 User to reveal its configuration section.

AMP users will need to configure all v3 users that are configured on the controller; the SNMP Inform receiver

in the AMP will be restarted when users are changed or added to the controller.

 Username - Username of the SNMP v3 user as configured on the controller.

 Auth Protocol - Can be MD5 or SHA. The default setting is SHA.

 Auth and Priv Passphrases - Enter the auth and priv passphrases for the user as configured on the

controller.

 Priv Protocol - Can be DES or AES. The default setting is DES.

4. Locate the Telnet/SSH Settings section, and complete or adjust the default value for the field. Table 21

shows the setting and default value.

5. Locate the HTTP Discovery Settings section and adjust the default value. Table 22 shows the setting and

default value.

NOTE: Community strings and shared secrets must have read-write access for AWMS to configure the devices. Without read-

write access, AWMS may be able to monitor the devices but cannot apply any configuration changes.

Table 20 Device Setup > Communication > SNMP Settings Fields and Default Values

Setting Default Description

SNMP Timeout 3 Sets the time, in seconds, that AWMS waits for a response from a device after

sending an SNMP request.

SNMP Retries 3 Sets the number of times AWMS tries to poll a device when it does not receive a

response within the SNMP Timeout Period or the Group's Missed SNMP Poll

Threshold setting (1-100). If AWMS does not receive an SNMP response from the

device after the specified number of retries, AWMS classifies that device as Down.

Table 21 Telnet/SSH Sett

ings Fields and Default Values

Setting Default Description

Telnet/SSH Timeout

(3-120 sec)

10 Sets the timeout period in seconds used when performing Telnet and SSH commands.

Table 22 HTTP Discovery Settings Fields and Default Values

Setting Default Description

HTTP Timeout

(3-120 sec)

5 Sets the timeout period in seconds used when running an HTTP discovery scan.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 281 282

Brak uwag

Dell PowerConnect W-Airwave 7.2 Instrukcja Użytkownika Strona 48