
60 | Configuring AWMS Dell PowerConnect W AirWave 7.2 | User Guide
3. Install a New Certificate by selecting the Install New Certificate button, or skip to the next step if the
certificate was previously installed.
4. Select User Setup in the left frame.
5. Enter the Username that will be used to authenticate into the WDS and select Add/Edit.
6. Enter the Password that will be used to authenticate into the WDS and select Submit.
7. Go to the Network Configuration > Add AAA Client page.
8. Add AP Hostname, AP IP Address, and Community String (for the key).
9. Enter the Password that will be used to authenticate into the WDS and select Submit.
For additional and more general information about ACS, refer to “Configuring ACS Servers” on page61.
Configuring Cisco WLSE Rogue Scanning
The AMP Setup > WLSE page allows AWMS to integrate with the Cisco Wireless LAN Solution Engine
(WLSE). AWMS can discover APs and gather rogue scanning data from the Cisco WLSE.
Figure 28 illustrates and itemizes the AWMS settings for communication that is enabled between AWMS and
WLSE.
Figure 28 AMP Setup > WLSE > Add WLSE Page Illustration
Perform the following steps for optional configuration of AWMS for support of Cisco WLSE rogue scanning.
1. To add a Cisco WLSE server to AWMS, navigate to the AMP Setup > WLSE page and select Add.
Complete the fields in this page. Table 32 describes the settings and default values.
Table 32 AMP Setup > WLSE Fields and Default Values
Setting Default Description
Hostname/IP Address None Designates the IP address or DNS Hostname for the WLSE server, which must
already be configured on the Cisco WLSE server.
Protocol HTTP Specifies the protocol to be used when polling the WLSE.
Port 1741 Defines the port AWMS uses to communicate with the WLSE server.
Username None Defines the username AWMS uses to communicate with the WLSE server. The
username and password must be configured the same way on the WLSE server and
on AWMS.
The user needs permission to display faults to discover rogues and inventory API
(XML API) to discover manageable APs. As derived from a Cisco limitation, only
credentials with alphanumeric characters (that have only letters and numbers, not
other symbols) allow AWMS to pull the necessary XML APIs.
Password None Defines the password AWMS uses to communicate with the WLSE server. The
username and password must be configured the same way on the WLSE server and
on AWMS.
As derived from a Cisco limitation, only credentials with alphanumeric characters
(that have only letters and numbers, not other symbols) allow AWMS to pull the
necessary XML APIs.
Komentarze do niniejszej Instrukcji