
56 | Configuring AWMS Dell PowerConnect W AirWave 7.2 | User Guide
Figure 26 AMP Setup > RADIUS Accounting
Page Illustration
Figure 27 AMP Setup > RADIUS > Add RADIUS Accounting Client Page Illustration
1. To specify the RADIUS authentication server or network, browse to the AMP Setup > RADIUS Accounting
page and select Add, illustrated in Figure 27, and provide the information in Table 30.
2. Select Add.
What Next?
For more information about configuring WLAN Gateways or WLAN controllers such as BlueSocket,
ReefEdge, or ProCurve wireless gateways, refer to “Third-Party Security Integration for AWMS” on page257.
Go to additional subtabs in AMP Setup to continue additional setup configurations.
Complete the required configurations in this chapter before proceeding. Dell support remains available to you for
any phase of AWMS installation.
Configuring Cisco WLSE and WLSE Rogue Scanning
The Cisco Wireless LAN Solution Engine (WLSE) includes rogue scanning functions that AWMS supports.
This section contains the following topics and procedures, and several of these sections have additional sub-
procedures:
Introduction to Cisco WLSE
Configuring WLSE Initially in AWMS
Configuring IOS APs for WDS Participation
Configuring ACS for WDS Authentication
Configuring Cisco WLSE Rogue Scanning
You must enter one or more CiscoWorks WLSE hosts to be polled for discovery of Cisco devices and rogue AP
information.
Table 30 AMP Setup > RADIUS Accounting Fields and Default Values
Setting Default Description
Nickname None Sets a user-defined name for the authentication server.
IP/Network None Cites the IP address or DNS Hostname for the authentication server if you only want to accept
packets from one device. To accept packets from an entire network enter the IP/Netmask of the
network (for example, 10.51.0.0/24).
Shared Secret
(Confirm)
None Sets the Shared Secret that is used to establish communication between AWMS and the
RADIUS authentication server.
Komentarze do niniejszej Instrukcji