Dell PowerConnect W-Airwave 7.2 Instrukcja Użytkownika Pobierz pdf (Strona 49)

Dell PowerConnect W AirWave 7.2 |User Guide Configuring AWMS | 49

6. Locate the ICMP Settings section and adjust the default value as required. Table 23 shows the setting and

default value.

7. Locate the Cisco Aironet VxWorks User Creation Options section. You only need to provide this information

if you use VxWorks-based Cisco APs on your network, as follows:

 Aironet 340

 Aironet 350

 Aironet 1200

Select one of the three options listed. Table 24 describes the settings and default values of this section.

8. Locate the Symbol 4131, Cisco Aironet IOS and Nomadix AG2000w SNMP Initialization area. Select one

of the options listed. Table 25 describes the settings and default values

Loading Device Firmware Onto AWMS (optional)

Overview of the Device Setup > Upload Firmware & Files Page

AWMS enables automated firmware distribution to the devices on your network. Once you have downloaded the

firmware files from the vendor, you can upload this firmware to AWMS for distribution to devices via the Device

Setup > Upload Firmware & Files page.

This page lists all firmware files on AWMS with file information. This page also enables you to add new firmware

files, to delete firmware files, and to add New Web Auth Bundle files.

The following additional pages support firmware file information:

Table 23 Device Setup > Communication > ICMP Settings Fields and Default Values

Setting Default Description

Attempt to ping

devices that

were

unreachable

via SNMP

Yes  When Yes is selected, AWMS attempts to ping the AP device.

 Select No if performance is affected in negative fashion by this function. If a large number

of APs are unreachable by ICMP, likely to occur where there is in excess of 100 APs, the

timeouts start to impede network performance.

NOTE: If ICMP is disabled on the network, select No to avoid the performance penalty caused

by numerous ping requests.

Table 24 Cisco Aironet VxWorks User Creation Options Fields and Default Values

Setting Default Description

Do not modify

security/SNMP

settings

N/A Enables AWMS using only an existing user account on the AP, as defined in the Cisco VxWorks

Username/Password section in the Default Secrets area. This user account must have all

permissions set.

Create and use

specified user

N/A Enables AWMS to create a new user account, specified below, on each AP with all

permissions enabled.

Table 25 Device Setup > Communications Fields and Default Values

Setting Default Description

Do Not Modify

SNMP Settings

Yes When selected, specifies that AWMS not modify any SNMP settings. If SNMP is not already

initialized on the Symbol, Nomadix, and Cisco IOS APs, AWMS is not able to manage them.

Enable read-write

SNMP

No When selected, and when on networks where the Symbol, Nomadix, and Cisco IOS APs do

not have SNMP initialized, this setting enables SNMP so the devices can be managed by

AWMS.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 281 282

Komentarze do niniejszej Instrukcji

Brak uwag

Dell PowerConnect W-Airwave 7.2 Instrukcja Użytkownika Strona 49

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell PowerConnect W-Airwave 7.2