Dell PowerConnect W-Airwave 8.0 Instrukcja Użytkownika Pobierz pdf (Strona 119)

119 | Configuring and Using Device Groups Dell Networking W-AirWave 8.0 | User Guide

4. Click the Change Device Group/Folder drop-down menu and select any of the supported changes. Table 70

describes these actions and controls. Any action you take applies to all selected devices.

Action Description

System Actions

Change Device

Group/Folder

Move the selected devices to a new group or folder. If the AP is in managed mode

when it is moved to a new group, it will be reconfigured. When you select this option,

you must also click the Group and/or Folder drop down menu and select the

destination group or folder for the devices. Click Move and then select Apply All to

save your changes.

Poll selected devices

Click Poll Now to poll selected devices for current user count and bandwidth data.

This action overrides default poll settings for the group. Polling numerous devices

may create a temporary performance load on your AirWave server.

Audit selected devices

Fetches the current configuration from the device and compares it to the desired

AirWave configuration. The audit action updates the Configuration Status.

NOTE: In versions of AirWave prior to 7.3, the Audit button appeared on Groups >

List for groups with audit disabled. Now, if a group has audit disabled for its devices,

AirWave does not show the Audit button in the Modify devices list.

Delete selected devices

Click Delete to remove the selected devices from AirWave. A new window opens

and asks you to confirm your changes. Select Apply Changes Now. The deletions

will be performed in the background and it may take a minute to remove the selected

devices from the list.

Run report on selected

devices

Takes you to the Reports > Definitions page where you can define or run a custom

report for selected devices. For more details and a procedure, see "Using Custom

Reports" on page 288.

Update the credentials

used to communicate with

these devices

Update changes the credentials AirWave uses to communicate with the device. It

does

not

change the credentials on the AP.

Import settings from

selected devices (and

discard current pre-

device desired settings)

Audit updates a number of the AP-specific settings that AirWave initially read off of

the AP including channel, power, antenna settings and SSL certifications. AirWave

recommends using this setting if APs have been updated outside of AirWave. Most

settings on the APs/Devices Manage configuration page are set to the values

currently read off of the devices.

Management Level

When you select this action, you must select either Monitor Only + Firmware

Upgrade or Manage Read/Write to choose new the management level for the

devices.

Replace Hardware

Select the down device that will be replaced and view the list of AirWave devices

that match the name or IP address of the selected device. The down devices can be

replaced with any device in the New Devices list or in the current folder or group.

Planned Downtime Mode

When you select this action, you must select either Enable or Disable to change the

downtime mode for the selected devices. When this option is enabled, the selected

devices are put into Planned Maintenance mode. When this mode is enabled, no AP

Down triggers will be deployed on these devices. Users will not be able to delete

folders that contain devices in Planned Maintenance. The devices in Planned

Maintenance will show the Up status, but will not be tracked in historical graphs and

logs as Up.

Table 70:

Modify Multiple Devices Section Fields and Default Values

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 376 377

Komentarze do niniejszej Instrukcji

Brak uwag

Dell PowerConnect W-Airwave 8.0 Instrukcja Użytkownika Strona 119

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell PowerConnect W-Airwave 8.0