Dell PowerConnect W-Airwave 8.0 Instrukcja Użytkownika Pobierz pdf (Strona 75)

Requirement Description

11.4

Using intrusion-detection or intrusion-prevention systems to monitor all traffic

When Enabled: AirWave reports pass or fail status when monitoring devices capable of

reporting IDS events. Recent IDS events are summarized in the PCI Compliance report

or the IDS Report.

When Disabled: AirWave does not monitor the presence of PCI-compliant intrusion

detection or prevention systems, nor can it report Pass or Fail status with regard to IDS

events.

Table 38:

PCI Requirements and Support in AirWave (Continued)

Enabling or Disabling PCI Auditing

Perform these steps to verify status and to enable or disable AirWave support for PCI 1.2 requirements. enabling one or

all PCI standards on AirWave enables real-time information and generated reports that advise on Pass or Fail status. The

PCI auditing supported in AirWave is reported in Table 1 in the "PCI Auditing" on page 73 section.

1. To determine what PCI Compliance standards are enabled or disabled on AirWave, navigate to the AMP Setup >

PCI Compliance page, illustrated in Figure 35.

Figure 35:AMP Setup > PCI Compliance page illustration

2. To enable, disable, or edit any category of PCI Compliance monitoring in AirWave, select the pencil icon next to the

category. The Default Credential Compliance page displays for the respective PCI standard.

3. Create changes as required. The edit pages will vary based on the PCIRequirement that you select. Figure 36 shows

an example of how to edit the PCI 2.1 requirement.

Dell Networking W-AirWave 8.0 | User Guide Configuring AirWave | 75

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 376 377

Brak uwag

Dell PowerConnect W-Airwave 8.0 Instrukcja Użytkownika Strona 75