Dell PowerConnect W-Airwave 8.0 Instrukcja Użytkownika Pobierz pdf (Strona 225)

225 | Performing Daily Administration in AirWave Dell Networking W-AirWave 8.0 | User Guide

Radio Trigger Options Description

Radio Down

Indicates that a device’s radio is down on the network. Once you choose this trigger

type, select Add New Trigger Condition to create at least one condition. This type

requires that a radio capability be set as a condition. The Value drop-down menu

supports several condition options.

Radio Up

Indicates that a device’s radio is up on the network. Once you choose this trigger

type, select Add New Trigger Condition to create at least one condition. This type

requires that a radio capability be set as a condition. The Value drop-down menu

supports several condition options.

802.11 Frame Counters

Enables monitoring of traffic levels. There are multiple rate-related parameters for

which you define conditions including ACK Failures, Retry Rate, and Rx Fragment

Rate. See the Option drop-down menu in the Conditions section of the trigger page

for a complete list of parameters. Select Add New Trigger Condition to access these

settings. Define at least one condition for this trigger type.

802.11 QoS Counters

Enables monitoring of Quality of Service (QoS) parameters on the network,

according to traffic type. The rate of different parameters includes ACK Failures,

Duplicated Frames and Transmitted Fragments. See the drop-down field menu in

the conditions section of the trigger page for a complete list of parameters. Select

Add New Trigger Condition to access these settings. Define at least one condition

for this trigger type.

Interface Usage

Interface labels defined on the trigger page will be used to set up triggers on one or

more interfaces and/or radios. Available conditions are Device Type, Interface

Description, Interface Label, Interface Mode, Interface Speed In (Mbps), Interface

Speed Out (Mbps), Interface Type, and Radio Type.

Channel Utilization

Indicates that channel utilization has crossed particular thresholds. Available

conditions are Interference (%), Radio Type, Time Busy (%), Time Receiving (%),

and Time Transmitting (%).

Radio Noise Floor

Indicates that the Noise Floor dBM has exceeded a certain value for aspecified

period of time.

Table 111:

Interfaces/Radio-Related Trigger Types

Setting Triggers for Discovery

Perform the following steps to configure triggers related to device discovery.

1. Choose a trigger type from the Discovery category, listed in the Type drop-down menu. See Figure 130 in "Creating

New Triggers" on page 220.

Discovery Trigger Options Description

New Device Discovered

This trigger type flags the discovery of a new AP, router, or switch connected to

the network (an device that AirWave can monitor and configure). Once you

choose this trigger type, select Add New Trigger Condition to specify a Device

Type (Access Point, Controller, Remote AP, or Router/Switch)

Table 112:

Discovery Trigger Types and Condition Settings

2. Repeat this procedure for as many triggers and conditions as desired. Refer to the start of "Creating New Triggers" on

page 220 to create a new trigger.

Setting Triggers for Clients

Perform the following steps to configure user-related triggers.

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 376 377

Komentarze do niniejszej Instrukcji

Brak uwag

Dell PowerConnect W-Airwave 8.0 Instrukcja Użytkownika Strona 225

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Dell PowerConnect W-Airwave 8.0