Dell Chassis Management Controller Version 4.50 Podręcznik Użytkownika Pobierz pdf (Strona 116)

rollback

Description Allows you to roll back the firmware to an earlier version.

Synopsis

racadm rollback <FQDD>

NOTE: To get the list of available rollback versions and FQDDs, run the racadm

swinventory command.

Input <FQDD>: Specify the FQDD that has the rollback version.

Example

• racadm rollback iDRAC.Embedded.1-1

• racadm rollback BIOS.Setup.1-1

serveraction

Description Enables you to perform power management operations on the host system.

To run this subcommand, you must have the Execute Server Control Commands permission.

Synopsis

racadm serveraction -a <action>

racadm serveraction -m <module> <action>

Input

• -m <module> — Must be one of the following values:

– server–n: where n=1–16

– server–nx: where n=1–8; x=a–d (enter lower case letter only)

• -a — Performs power action on all servers. Not allowed with the powerstatus action.

NOTE: The -m and -a options are applicable only to CMC platforms.

• <action> — Specifies the action. The options for the <action> string are:

– hardreset — Performs a reset (reboot) operation on the managed system.

– powercycle — Performs a power-cycle operation on the managed system. This action is

similar to pressing the power button on the system’s front panel to turn off and then turn on

the system.

NOTE: If the server is in turned off state, the powercycle option power up the server.

– powerdown — Powers down the managed system.

– powerup — Powers up the managed system.

– powerstatus — Displays the current power status of the server (ON or OFF).

– graceshutdown — Performs a graceful shutdown of the server. If the operating system

on the server cannot be shut down completely, then this operation is not performed.

– -f — Force the server power management operation.

For iDRAC only: This option is applicable only for the PowerEdge-VRTX platform. It is used

with powerdown,powercycle, and hardreset options.

For CMC only:

– reseat — Performs virtual reseat of the server. This operation simulates reseating the

blade by resetting the iDRAC on that blade.

-f is required for this operation.

116

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 427 428

Brak uwag

Dell Chassis Management Controller Version 4.50 Podręcznik Użytkownika Strona 116