Dell Chassis Management Controller Version 4.50 Podręcznik Użytkownika Pobierz pdf (Strona 43)

only be a single update operation in progress at any time. In addition, the fwupdate subcommand

may only update one or more devices of a single kind at a time.

To use this subcommand for CMC, you must have the Chassis Configuration Administrator privilege

and for iDRAC you must have Configure iDRAC permission.

NOTE:

• Running the fwupdate subcommand to update the firmware on the active CMC resets itself

and all the network connections are dropped. During update of all other modules, including

the standby CMC, the active CMC continues to run normally without resetting.

• In a chassis supported by DC PSUs, an error message is displayed if you attempt to update

the firmware with a version without DC PSU support.

NOTE: The fwupdate subcommand generates an error when used on the extension slot of a

multi-slot server.

Synopsis

For iDRAC:

racadm fwupdate -s

racadm fwupdate -g -u -a <TFTP_Server_IP_Address>

[-d <path> [--clearcfg]

racadm -r <iDRAC7 IP_Address> -u <username> -p <password> fwupdate

-f <ftpserver ip> <ftpserver username> <ftpserver password> -d

<path> where path is the location on the ftp server where

firming.d7 is stored.

racadm fwupdate -r

racadm fwupdate -p -u [-d <path>]

For CMC:

For local RACADM:

racadm fwupdate -g -u -a <tftp server ip address or

FQDN> -d <path> [-m <module>]

racadm fwupdate -f <ftp server ip address or FQDN>

<username> <password> -d <path> [-m

<module>]

racadm fwupdate -u -m iominf-<n>

racadm fwupdate -s [-m <module>]

racadm fwupdate -c [-m <module>]

For Remote RACADM:

racadm fwupdate -p -u -d <firmware image>

NOTE: iDRAC7 targets are not supported from CMC. To update iDRAC7 targets, use the CMC

GUI.

When using FTP, if you provide the full path to the image file on theCLI, then the CMC uses that

path to locate that file on the host. If full path is not provided and the host system is running Linux or

another variant of UNIX , then CMC searches the home directory of the specified user for the file. If

the host system is running Windows, then a default folder, such as C:\ftproot is searched.

NOTE: When attempting to run firmware update task using racadm fwupdate command, if the

firmware image path length is greater than 256 characters. Remote RACADM client exits with

the error message "ERROR: Specified path is too long".

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 427 428

Komentarze do niniejszej Instrukcji

Brak uwag

Dell Chassis Management Controller Version 4.50 Podręcznik Użytkownika Strona 43

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Serwery Dell Chassis Management Controller Version 4.50